This can result in pressurized air entering the can, preventing the solution from inside of the butane canister to fill the torch properly. *DO NOT HOLD THE TORCH SIDEWAYS WHILE FILLING*. Hold for 4-6 seconds to fill an empty torch. *NEVER TRY TO REFILL A FULL TORCH* Make sure you keep the tip facing directly to the floor so that the solution inside can makes its way into the torch. With the other hand insert the tip of your butane canister into the fill port. Hold your torch at waist to chest level with one hand and angle the fill port so that it faces you. Make sure your torch valve is closed so no gas escapes when filling. Some models do not have this plug and you can already see the fill port. We recommend to take the torch out of the base whenever you want to fill it. When filling your RiO torch you need to remove the silicone plug covering the fill port on the back of the base. Place your thumb above the ignition and turn the torch back and forth while pulling forward. Do not remove the torch from base when hot/ after immediate use. Grab the cold torch from black plastic covering located below the nozzle. When removing the torch from the base you want to take off the silicone plug covering the back of the torch. Afterward wash with hot water.įILLING YOUR TORCH : fill for 3-5 seconds no need for anymore. Place your plug into the piece and shake clean. You will then pour out the alcohol until about ¼ -½ of the solution is left. After cleaning, wash the solution away with hot water.Īnother way to clean your glass is to soak the whole piece into isopropyl alcohol and let it sit in the solution for 4-24 hours. Once the salt is in the glass insert your silicone plugs or use your fingers to cover the holes. Once the ISO is in the glass pour a small amount of coarse salt into the piece (roughly a teaspoon-tablespoon amount). You want to then pour isopropyl into the glass piece about ¼-½ way full. Make sure you empty your glass of all water prior to cleaning. *DO NOT PULL IT FROM THE NECK*.įor a quick and easy clean of your RiO glass we suggest using isopropyl alcohol and coarse salt. Firmly grasp the glass and wiggle the glass side to side while pulling in an upwards motion. Make sure the neck of the glass is facing away from you so that the opened end of the mouthpiece is not facing you. To remove the glass grab the base of the RiO by placing your less dominant hand under the base and your dominant hand over top of the glass.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |